hey i am jsut starting a project car and i have a d16z6 motor out of a 93 civic si and i am putting it in a 89 crx dx i was jsut needing some help i didnt know if the motor mounts are the same or if they make mounts for the swap like the b16 or what they did i am also looking for a gauge cluster for the crx and some interior peices if anybody has some laying around i am in kansas city and will travel if its not to far i am also looking for a drivers door for it and i am jsut looking for info before i do the swap so any info would be helpful becasue this is my first swap but i read honda tuning alot so i kinda know what i am doing so email me at aemallen1@cougars.ccis.edu

Alex  

I used a 4th gen cable tranny.  Use the 89 driverside mount, it will be rotated forward a little, but I have had no problems.  

use the motor mount off the original chassis , then u have too change the attaching bracket behind the timing cover. the best trans too use is the 88-91 si trans.its cable and will bolt right up too the d16. its close ratio and low final drive will make it a blast too drive w/d16z6. im using the same setup in my 91 except im using a modded d16y8.its a blast.